某1 000 MW机组电除尘器气固两相流数值模拟
Numerical simulation of gas-solid two-phase flow in electrostatic precipitator of 1 000 MW unit
-
摘要: 流场分布对电除尘性能至关重要。采用商业CFD软件，对某1 000 MW机组电除尘器进行了数值模拟。模拟过程中采用离散相模型（DPM）结合k-ε湍流模型，模拟颗粒运动轨迹。研究了在合理布置烟道走向，并在烟道内布置导流板、阻流板，在进口喇叭内布置气流分布板及导流叶片等措施条件下，电除尘器的气固两相流参数。结果表明：烟道内布置导流板及阻流板后，电除尘器各分室进口流量偏差均在±2%以内，出口流量偏差均不超过±0.5%，远优于标准要求；颗粒相质量流量分配偏差也均未超过5%，且各级粒径分布所对应偏差也明显减小；电除尘器各室入口截面烟气流速相对均方根差均不超过0.15，优于标准要求。Abstract: The distribution of the flow field is of great significance to the performance of electrostatic precipitator (ESP). Commercial CFD software was used to simulate the ESP performance of a 1 000 MW unit. Discrete phase model (DPM) combined with k-ε turbulence model was used to simulate the particle motion trajectory. The gas-solid two-phase flow parameters of electrostatic precipitator were studied under the conditions of reasonable layout of the flue with deflectors and baffles, and reasonable arrangement of air distribution plates and guide vanes in the inlet horn. The results show that after the deflectors and baffles are arranged in the flue, the inlet flow deviation of the ESP in each chamber is within ±2%, and the outlet flow deviation is not more than ±0.5%, which is much better than the standard requirements. The mass flow rate distribution deviation of the particle phase does not exceed 5%, and the corresponding particle size distribution at all levels are also significantly reduced. The relative root-mean-square deviation of the smoke flow velocity at the inlet section of each chamber of the ESP does not exceed 0.15, which is also far better than the standard requirement.
-
-
[1] MOKHTARZADEH-DEHGHAN M R,YUAN Y M．Measurements of turbulence quantities and bursting period in developing turbulent boundary layers on the concave and convex walls of a 90 square bend[J]．Experimental Thermal and Fluid Science,2002,27(1):59-75 10.1016/j.expthermflusci.20021303 [2] NIKAS K S P, VARONOS A A．Numerical simulation of the flow and the collection mechanisms inside a laboratory scale electrostatic precipitator[J]．Journal of Electrostatics,2005,63 (5):423-443 10.1016/j.elstat.2004.12.005 [3] SWAMINATHAN M R, MAHALAKSHMI N V.Numerical modelling of flow through perforated plates applied to electrostatic precipitator[J].Journal of Applied Sciences,2010,10(20):2426-2432 [4] GUO B Y, HOU Q F, YU A B, et al.Numerical modelling of the gas flow through perforated plates[J].Chemical Engineering Research and Design,2013,91(3):403-408 10.1016/j.cherd.2012.10.004 [5] 齐晓娟,李凤瑞,周晓耘． 电除尘器进口矩形烟道气流布改进的CFD 模拟[J]． 环境工程学报,2011,5(2):404-408 [6] 邵毅敏,周俭基,熊绍武,等． 电除尘器进气烟箱参数对气流分布影响的仿真研究[J]环境工程学报,2012,6(2):577-583 [7] 陈冠益,耿页,郑乐宇,等. 带有内撑结构的电厂烟道弯头压力损失数值模拟[J].中国电机工程学报,2013,33(增刊):153-159 [8] 刘忠,刘含笑,冯新新,等. 湍流聚并器流场和颗粒运动轨迹模拟[J].中国电机工程学报,2012,32(14):71-75 [9] 刘含笑,姚宇平,郦建国. 湍流场中颗粒破碎的数值模拟[J].环境工程学报,2015,9(8):3937-3943 [10] 李立锋,叶兴联,杨丁. 湿式电除尘器系统流场数值模拟分析[J].环境工程学报,2015,9(10):4959-4964 [11] 李婉婉,刘丽萍,贾燕,等. 某1 000 MW机组电除尘器前后烟道流场特性数值模拟及结构优化[J].热力发电,2016,45(9):15-22 [12] 贾燕,崔浩,李婉婉,胡国明. 三室电除尘器前烟道的数值模拟与结构优化[J].热能动力工程,2016,31(9):88-93 [13] 何林菊,骆建友,赵胜清,等.低温电除尘器数值模拟研究[J]. 环境工程,2014,32(S):391-394 [14] 袁伟锋, 周统. 低低温电除尘系统改造数值试验研究[C]//中国环保产业协会电除尘委员会.第十七届中国电除尘学术会议论文集.合肥,2017 [15] SHIH T H, LIOU W W, SHABBIR A, et al.A new k-eddy-viscosity model for high reynolds number turbulent flows-model development and validation [J].Computers Fluids, 1995,24(3):227-238 10.1016/0045-7930(94)00032-T -
点击查看大图
计量
- 文章访问数: 2482
- HTML全文浏览数: 2189
- PDF下载数: 266
- 施引文献: 0
下载:
