高级搜索

铁源对碳热合成磁性碳质吸附剂的影响

,  ,  , 

downloadPDF

上一篇

下一篇

柯杭, 张芳, 李广贺, 张旭. 铁源对碳热合成磁性碳质吸附剂的影响[J]. 环境工程学报, 2017, 11(9): 4917-4922. doi: 10.12030/j.cjee.201610171
引用本文: 柯杭, 张芳, 李广贺, 张旭. 铁源对碳热合成磁性碳质吸附剂的影响[J]. 环境工程学报, 2017, 11(9): 4917-4922. doi: 10.12030/j.cjee.201610171
shu
KE Hang, ZHANG Fang, LI Guanghe, ZHANG Xu. Influence of iron precursor in carbothermal synthesis of magnetic carbonaceous adsorbents[J]. Chinese Journal of Environmental Engineering, 2017, 11(9): 4917-4922. doi: 10.12030/j.cjee.201610171
Citation: KE Hang, ZHANG Fang, LI Guanghe, ZHANG Xu. Influence of iron precursor in carbothermal synthesis of magnetic carbonaceous adsorbents[J]. Chinese Journal of Environmental Engineering, 2017, 11(9): 4917-4922. doi: 10.12030/j.cjee.201610171
shu

铁源对碳热合成磁性碳质吸附剂的影响

  • 1.

    清华大学环境学院, 环境模拟与污染控制国家重点联合实验室, 北京 100084

  • 基金项目:

    国家高技术研究发展计划（863）项目（2013AA06A207）

  • 中图分类号: X52

Influence of iron precursor in carbothermal synthesis of magnetic carbonaceous adsorbents

  • 1.

    State Key Joint Laboratory of Environment Simulation and Pollution Control, School of Environment, Tsinghua University, Beijing 100084, China

  • Fund Project:

  • 摘要: 评价了不同铁源对碳热法合成磁性碳质吸附剂吸附三氯乙烯的影响。选择3种铁盐作为铁源合成3类磁性碳质吸附剂：氯化铁、硝酸铁和硫酸亚铁。所有吸附剂分别在600、700、800℃条件下以蔗糖为碳源进行合成。对制得的吸附剂使用氮气吸附、扫描电子显微镜、X射线衍射等技术进行表征。3类吸附剂呈现了不同的结构性质、铁组分分布及成分，因此导致对三氯乙烯吸附去除能力有显著差异。通过实验研究了制得的吸附剂对三氯乙烯的吸附动力学，并用准二级动力学模型对数据进行拟合。结果表明氯化铁是用于吸附三氯乙烯的磁性碳质吸附剂合成的最佳铁源。
    Abstract: In this work,the influence of the iron precursor for carbothermal synthesis of magnetic carbonaceous adsorbents towards trichloroethylene removal was evaluated. Three iron salts were used to get three kinds of magnetic carbonaceous adsorbents:ferric chloride, ferric nitrate and ferrous sulfate. All adsorbents were prepared at different temperatures of 600, 700, 800℃ using sucrose as carbon source. The characterization of prepared adsorbents was done by different techniques such as nitrogen adsorption, scanning electron microscopy, X-ray diffraction and so on. The three kinds of adsorbents presented different textural properties, iron dispersion and composition, thus leading to quite different abilities of trichloroethylene adsorption. The adsorption kinetics of the prepared adsorbents for trichloroethylene removal was performed and pseudo-second order kinetics equation was used to fit the data. In present study, ferric chloride was the best option of the precursor to synthesize magnetic carbonaceous adsorbents for trichloroethylene removal.
  • 加载中
  • [1] AHMAD M, LEE S S, RAJAPAKSHA A U, et al. Trichloroethylene adsorption by pine needle biochars produced at various pyrolysis temperatures[J]. Bioresource Technology, 2013, 143(1):615-622
    [2] COOPER A M, HRISTOVSKI K D, MÖLLER T, et al. The effect of carbon type on arsenic and trichloroethylene removal capabilities of iron (hydr)oxide nanoparticle-impregnated granulated activated carbons[J]. Journal of Hazardous Materials, 2010, 183(1/2/3):381-388
    [3] LIANG C, LEE P H. Granular activated carbon/pyrite composites for environmental application:Synthesis and characterization[J]. Journal of Hazardous Materials, 2012, 231-232(6):120-126
    [4] YUE Z, ECONOMY J. Nanoparticle and nanoporous carbon adsorbents for removal of trace organic contaminants from water[J]. Journal of Nanoparticle Research, 2005, 7(4):477-487
    [5] ZHU X, LIU Y, ZHOU C, et al. A novel porous carbon derived from hydrothermal carbon for efficient adsorption of tetracycline[J]. Carbon, 2014, 77(10):627-636
    [6] WEI Z, SEO Y. Trichloroethylene (TCE) adsorption using sustainable organic mulch[J]. Journal of Hazardous Materials, 2010, 181(1/2/3):147-153
    [7] MOHAN D, SARSWAT A, SINGH V K, et al. Development of magnetic activated carbon from almond shells for trinitrophenol removal from water[J]. Chemical Engineering Journal, 2011, 172(2/3):1111-1125
    [8] DO M H, PHAN N H, NGUYEN T D, et al. Activated carbon/Fe3O4 nanoparticle composite:Fabrication, methyl orange removal and regeneration by hydrogen peroxide[J]. Chemosphere, 2011, 85(8):1269-1276
    [9] 杨梖,白雪,顾海鑫.磁性吸附材料的制备及其在污水处理中的应用[J].环境工程,2015,33(4):25-29
    [10] TSENG H, SU J, LIANG C. Synthesis of granular activated carbon/zero valent iron composites for simultaneous adsorption/dechlorination of trichloroethylene[J]. Journal of Hazardous Materials, 2011, 192(2):500-506
    [11] LIU X, ZHANG D, GUO B, et al. Facile Synthesis of mesoporous FeNi-alloyed carbonaceous microspheres as recyclable magnetic adsorbents for trichloroethylene removal[J]. RSC Advance, 2015, 5(113):93491-93498
    [12] ZHUANG L, LI Q, CHEN J, et al. Carbothermal preparation of porous carbon-encapsulated iron composite for the removal of trace hexavalent chromium[J]. Chemical Engineering Journal, 2014, 253(7):24-33
    [13] YANG R, WANG Y, LI M, et al. A new carbon/ferrous sulfide/iron composite prepared by an in situ carbonization reduction method from hemp (Cannabis sativa L.) stems and its Cr(Ⅵ) removal ability[J]. ACS Sustainable Chemistry & Engineering, 2014, 2(5):1270-1279
    [14] SU Y, CHENG Y, SHIH Y. Removal of trichloroethylene by zerovalent iron/activated carbon derived from agricultural wastes[J]. Journal of Environmental Management, 2013, 129:361-366
    [15] SUN H, ZHOU G, LIU S, et al. Nano-Fe0 encapsulated in microcarbon spheres:Synthesis, characterization, and environmental applications[J]. ACS Applied Materials & Interfaces, 2012, 4(11):6235-6241
    [16] LVOV B V. Mechanism of carbothermal reduction of iron, cobalt, nickel and copper oxides[J]. Thermochimica Acta, 2000, 360(2):109-120
    [17] BLEYL S, KOPINKE F, MACKENZIE K. Carbo-iron®:Synthesis and stabilization of Fe(0)-doped colloidal activated carbon for in situ groundwater treatment[J]. Chemical Engineering Journal, 2012, 191(1):588-595
    [18] 施周,王莉,邓林,等.NiFe2O4/ZnAl-LDH吸附去除水中Cr(Ⅵ)[J].环境工程学报,2016,10(9):4635-4642
    [19] CHUANG Y H, TZOU Y M, WANG M K, et al. Removal of 2-chlorophenol from aqueous solution by Mg/Al layered double hydroxide (LDH) and modified LDH[J]. Industrial & Engineering Chemistry Research, 2008, 47(11):3813-3819
    [20] 张婧怡,石宝友,解建坤,等.活性炭物化性质对吸附天然水体中有机污染物的影响[J].环境科学,2011,32(2):494-500
    [21] LI L, QUINLIVAN P A, KNAPPE D R U. Effects of activated carbon surface chemistry and pore structure on the adsorption of organic contaminants from aqueous solution[J]. Carbon, 2002, 40(12):2085-2100
    [22] ERTO A, ANDREOZZI R, LANCIA A, et al. Factors affecting the adsorption of trichloroethylene onto activated carbons[J]. Applied Surface Science, 2010, 256(17):5237-5242
  • 加载中
WeChat 点击查看大图
计量
  • 文章访问数:  1968
  • HTML全文浏览数:  1510
  • PDF下载数:  668
  • 施引文献:  0
出版历程
  • 收稿日期:  2016-12-20
  • 刊出日期:  2017-08-26
柯杭, 张芳, 李广贺, 张旭. 铁源对碳热合成磁性碳质吸附剂的影响[J]. 环境工程学报, 2017, 11(9): 4917-4922. doi: 10.12030/j.cjee.201610171
引用本文: 柯杭, 张芳, 李广贺, 张旭. 铁源对碳热合成磁性碳质吸附剂的影响[J]. 环境工程学报, 2017, 11(9): 4917-4922. doi: 10.12030/j.cjee.201610171
shu
KE Hang, ZHANG Fang, LI Guanghe, ZHANG Xu. Influence of iron precursor in carbothermal synthesis of magnetic carbonaceous adsorbents[J]. Chinese Journal of Environmental Engineering, 2017, 11(9): 4917-4922. doi: 10.12030/j.cjee.201610171
Citation: KE Hang, ZHANG Fang, LI Guanghe, ZHANG Xu. Influence of iron precursor in carbothermal synthesis of magnetic carbonaceous adsorbents[J]. Chinese Journal of Environmental Engineering, 2017, 11(9): 4917-4922. doi: 10.12030/j.cjee.201610171
shu

铁源对碳热合成磁性碳质吸附剂的影响

  • 1. 清华大学环境学院, 环境模拟与污染控制国家重点联合实验室, 北京 100084
  • 收稿日期:  2016-12-20
基金项目:

国家高技术研究发展计划（863）项目（2013AA06A207）

摘要: 评价了不同铁源对碳热法合成磁性碳质吸附剂吸附三氯乙烯的影响。选择3种铁盐作为铁源合成3类磁性碳质吸附剂：氯化铁、硝酸铁和硫酸亚铁。所有吸附剂分别在600、700、800℃条件下以蔗糖为碳源进行合成。对制得的吸附剂使用氮气吸附、扫描电子显微镜、X射线衍射等技术进行表征。3类吸附剂呈现了不同的结构性质、铁组分分布及成分，因此导致对三氯乙烯吸附去除能力有显著差异。通过实验研究了制得的吸附剂对三氯乙烯的吸附动力学，并用准二级动力学模型对数据进行拟合。结果表明氯化铁是用于吸附三氯乙烯的磁性碳质吸附剂合成的最佳铁源。

English Abstract

    全文HTML

参考文献 (22)

返回顶部

目录

/

返回文章
返回

Copyright © 2019 中国科学院生态环境研究中心